Nonlinear Model-Based Fault Detection for Industrial Applications
A special issue of Sensors (ISSN 1424-8220). This special issue belongs to the section "Fault Diagnosis & Sensors".
Deadline for manuscript submissions: closed (10 May 2023) | Viewed by 2296
Special Issue Editors
Interests: fault detection; fault tolerant control; wind turbines
Special Issues, Collections and Topics in MDPI journals
Interests: system identification and data analysis; artificial intelligence; neural networks; fuzzy systems; fault diagnosis; fault tolerant control; aircraft and spacecraft systems; energy conversion systems
Special Issues, Collections and Topics in MDPI journals
Special Issue Information
Dear Colleagues,
Motivated by the need for reliable and safe modern industrial systems, Fault Detection and Isolation (FDI) schemes are the most sought-after solutions in the last two decades. FDI schemes can help with timely detection, identification, and isolation of any faults. Then, corresponding corrective measures can be taken. Moreover, FDI information can be used to optimize the maintenance procedures and reduce the operational cost.
As a standard definition, deviation from the normal or standard condition of any parameter of the system can be translated as a fault, categorized as actuator faults, sensor faults, and plant faults. The concept of redundancy is often used to construct FDI schemes, amongst these, the model-based FDI has received a great deal of attention, since it can be specifically designed for the system of interest and the fault could be directly detected and isolated. Moreover, it resolves the problems associated with hardware redundancy approaches.
However, model-based FDI approaches have been mostly designed for the simple or linearized model of systems. This also requires the accurate knowledge of system dynamics. Moreover, the inevitable sources of unknown nonlinearities, model uncertainties, exogenous disturbances, and inadequate measurable outputs make the FDI design for industrial systems challenging.
This motivates the aim of this Special Issue of Sensors. Accordingly, I cordially invite researchers to contribute original and unique articles, as well as review papers. The topics of interest include (with emphasis on practical industrial systems), but are not limited to:
- Condition monitoring;
- Fault detection and isolation;
- Data-driven approaches including machine learning methods;
- Fault detection and diagnosis;
- Incipient faults;
- Industrial systems;
- Model-based approaches;
- Nonlinear models;
- Observer design;
- Unknown inputs.
Dr. Hamed Habibi
Dr. Silvio Simani
Guest Editors
Manuscript Submission Information
Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.
Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Sensors is an international peer-reviewed open access semimonthly journal published by MDPI.
Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2600 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.
