Advanced High-Strength Steels (AHSS) Prepared as Bulk and Powder Metal
A special issue of Materials (ISSN 1996-1944). This special issue belongs to the section "Metals and Alloys".
Deadline for manuscript submissions: 20 December 2024 | Viewed by 139
Special Issue Editor
Interests: plastic deformation; materials properties; microstructures; ultrafine-grained structures; nanostructures; additive manufacturing; cryorolling
Special Issues, Collections and Topics in MDPI journals
Special Issue Information
Dear Colleagues,
Advanced High Strength Steels (AHSS) are characterized by selected chemical composition, final microstructures, and physical properties that can be formed in bulk or powdered steel materials.
The steel properties in bulk form are formed via a controlled process of heating and plastic deformations in austenitic regions, with the possibility of continuing deformations in the dual phase region (γ + α), followed by controlled cooling. The processes of recrystallization, precipitation, and phase transformations are controlled by time-dependent thermal-deformation regimes, which influence the final mechanical properties.
Nowadays, trends in production are directed towards creating products by methods enabling the achievement of shapes and geometric dimensions near the final product using additive manufacturing (AM) techniques for steels prepared by powder metallurgy.
To increase the mechanical properties and minimize the density of the PM material, plastic deformations realized as SPD techniques (severe plastic deformation) or deformations realized in cryogenic temperatures with the possibility of heat treatment are used as post-processing techniques after AM. The accumulation of these techniques controls the processes of recrystallization, precipitation, and phase transformations, as well as the strengthening contributions to yield strength and optimization of plastic properties.
The yield strength, tensile strength, and area reduction depend on the control of the strengthening contributions (grain size refinement, precipitation strengthening, dislocation strengthening, and transformation strengthening).
This Special Issue aims to present the latest works in the research and development of AHSS steels. We invite you to submit a manuscript to this Special Issue. Full papers, communications, and reviews are welcome for submission.
Potential topics include, but are not limited to:
(a) Materials base: AHSS steels prepared in bulk and PM form (introduction and characterization);
(b) Experimental techniques: controlled rolling and cooling, additive manufacturing, SPD techniques, plastic deformations at cryogenic temperatures, and heat treatment;
(c) Strengthening mechanisms to increase mechanical properties;
(d) New trends to increase mechanical properties;
(e) Application of AHSS.
Prof. Dr. Tibor Kvačkaj
Guest Editor
Manuscript Submission Information
Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.
Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Materials is an international peer-reviewed open access semimonthly journal published by MDPI.
Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2600 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.
Keywords
- AHSS
- recrystallization
- precipitation
- phase transformation
- structures with dimensions at the level of micro and nano size
- grain size dimensions
- mechanical properties
- plastic deformations
- deep drawing
- additive manufacturing
- SPD techniques
- heat treatment
