Advances in High-Strength Materials Processing: Machining, Surface Integrity Management, and Operational Properties
A special issue of Applied Sciences (ISSN 2076-3417). This special issue belongs to the section "Materials Science and Engineering".
Deadline for manuscript submissions: 30 September 2024 | Viewed by 681
Special Issue Editors
Interests: machining of hard-to-cut materials, e.g., stainless steel, titanium and its alloys; physical phenomena of the cutting process; shaping the geometric structure of the materials surface; friction and wear behavior of materials; cooling and lubrication conditions during machining
Interests: machining of hard-to-cut and unconventional materials, e.g., stainless steels, titanium alloys, powder metallurgy materials; physical phenomena of the cutting process; shaping the material surface texture; wear behavior of cutting tools; friction and wear behavior of the aforementioned materials and coatings; cooling and lubrication conditions during machining; plasma and laser processing conditions
Special Issue Information
Dear Colleagues,
High-strength materials are now widespread, from medical implants to products used in aerospace, the automotive industry or marine environments. Such a wide range of applications entails the use of both steels and non-ferrous alloys, as well as unconventional materials, including ceramics, composites, multilayer alloys, etc. The main advantages of these groups of materials are their attractive structural, mechanical, thermal properties, which, in its turn, means the use of such technologies such as high-temperature thermo-mechanical processing, powder metallurgy processing, plasma or laser coating, additive manufacturing technologies, and so on. On the other hand, it is necessary to ensure the high efficiency and quality of production processes, which is not an easy task because these materials are considered to be hard to cut.
The main aims and scopes of this Special Issue are to explore the latest advancements in the following field:
- Details of chip shaping under machining of high-strength and unconventional materials;
- Physical phenomenon of cutting and abrasive processing;
- Modern designs of cutting and abrasive tools;
- The use of effective technological environments, such as near-dry cutting, minimum cooling and lubrication, high-pressure cooling, etc.;
- The impact of cutting and abrasive processing on the machined surface texture and the surface layer integrity;
- Development of high-performance and high-speed cutting;
- Friction and wear behavior of the surface machined.
Dr. Kamil Leksycki
Prof. Dr. Eugene Feldshtein
Guest Editors
Manuscript Submission Information
Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.
Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Applied Sciences is an international peer-reviewed open access semimonthly journal published by MDPI.
Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2400 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.
Keywords
- high-strength and unconventional materials
- work-piece and tool coatings
- cutting and abrasive processes
- surface texture
- surface layer integrity
- friction and wear behavior
- high-performance and high-speed cutting
