Casting Alloy Design and Characterization—2nd Edition
A special issue of Metals (ISSN 2075-4701). This special issue belongs to the section "Metal Casting, Forming and Heat Treatment".
Deadline for manuscript submissions: 31 December 2024 | Viewed by 25
Special Issue Editors
Interests: materials science and engineering; solidification; material testing; wear; manufacturing processes
Special Issues, Collections and Topics in MDPI journals
Interests: materials science and engineering; solidification; material testing; corrosion sciences; microscopy
Special Issues, Collections and Topics in MDPI journals
Special Issue Information
Dear Colleagues,
Metal casting processes normally used in the foundry industry (e.g., gravity or pressure casting) are subjected to a wide range of operational parameters. Consequently, a variety of solidification microstructures are formed, directly affecting mechanical, physical and chemical properties, strength–ductility response, corrosion and wear resistance, electrical conductivity, and others. In general, aspects such as the phase and microconstituents present, grain size, macrostructure morphology, porosity, and alloying segregation are responsible for defining the main properties of the final casting. Since there is a close correlation between solidification conditions, microstructure and properties, the effects of solidification conditions and alloying elements on microstructure design and the resulting properties in cast alloys have stimulated new research interest. In addition, it is fundamental to understand the influence of these characteristics on subsequent manufacturing processes such as heat treatment, forming, welding and machining.
The possibility of replacing wrought alloys with cast alloys, with associated cost reduction and improved mechanical properties, has motivated the modern industry to design new alloys by adding new elements or by using additive manufacturing techniques. Thus, this Special Issue aims to collect research articles focused on the design and characterization of cast alloys, especially on the interrelationship between solidification, microstructure and properties; both experimental and theoretical research is welcome.
The scope of the Special Issue includes, but is not limited to, the following technical topics:
- Casting processes and novel techniques;
- Solidification: experimental and theoretical studies;
- Microstructure and property characterization;
- Numerical and analytical simulations;
- Heat and mass transfer;
- Processing-structure-property relations;
- Industrial applications.
Dr. Carlos Alexandre Dos Santos
Dr. Eleani Maria Da Costa
Guest Editors
Manuscript Submission Information
Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.
Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Metals is an international peer-reviewed open access monthly journal published by MDPI.
Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2600 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.
Keywords
- casting
- solidification
- microstructures
- properties
- characterization
- casting design
Related Special Issue
- Casting Alloy Design and Characterization in Metals (11 articles)
