Structural Analysis, Phase Composition and Properties of Alloys and Steels Manufactured by 3D Printing
A special issue of Metals (ISSN 2075-4701). This special issue belongs to the section "Additive Manufacturing".
Deadline for manuscript submissions: closed (31 October 2021) | Viewed by 558
Special Issue Editor
Interests: steel and alloys; phase transformation; structure; TEM; properties; additive technology
Special Issues, Collections and Topics in MDPI journals
Special Issue Information
Dear Colleagues,
As Guest Editor, it is my great pleasure to invite you to submit your paper to the Special Issue "Structural Analysis, Phase Composition and Properties of Alloys and Steels Manufactured by 3D Printing " in a Highly Cited “Metals - Open Access Journal”, IF: 2.351 (2020). The main aim of this Special Issue is to cover recent progress in decisions of the problems related to the additive manufacturing of steel products. This Issue will collect research concerning different methods of 3D metal printing by powder laser, electron beam, and metal wire, including the following:
- Problems of laser or electron beam 3D printing from the steel powder and metal steel wire, post-printing treatments;
- Structure evolution of 3D printed steels after heat treatments and mechanical tests, martensitic and precipitation hardening in 3D steels;
- Physical properties of 3D printed steels;
- Design of 3D steel products.
Scientific papers reporting new and unpublished results on any aspect of these topics are welcomed.
Dr. Nataliya V. Kazantseva
Guest Editor
Manuscript Submission Information
Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.
Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Metals is an international peer-reviewed open access monthly journal published by MDPI.
Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2600 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.
Keywords
- Microstructure of 3D printed steels
- 3D design of steel products
- Physical and mechanical properties of 3D printed steel products
