Research on High-Heat-Input Welding and Three-Dimensional Printing
A special issue of Materials (ISSN 1996-1944). This special issue belongs to the section "Manufacturing Processes and Systems".
Deadline for manuscript submissions: closed (20 April 2024) | Viewed by 127
Special Issue Editor
Special Issue Information
Dear Colleagues,
This Special Issue aims to focus on high-heat-input welding, e.g., laser welding and plasma and welding, which involves welding with high-heat-input for obtaining greater welding efficiency than conventional welding processes.
We invite submissions of papers that address optimization of welding conditions, changes in mechanical properties after welding, numerical analysis based on the finite element of welding, challenges in 3D printing and WAAM (wire arc additive manufacturing), etc.
Dr. Jaewoong Kim
Guest Editor
Manuscript Submission Information
Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.
Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Materials is an international peer-reviewed open access semimonthly journal published by MDPI.
Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2600 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.
Keywords
- laser welding
- plasma welding
- 3D printing
- wire arc additive manufacturing
