Powder Recycling for 3D Printing Additive Manufacturing
A special issue of Applied Sciences (ISSN 2076-3417). This special issue belongs to the section "Additive Manufacturing Technologies".
Deadline for manuscript submissions: closed (30 March 2024) | Viewed by 205
Special Issue Editor
Special Issue Information
Dear Colleagues,
Powder recycling has attracted significant interest from industry and manufacturing research groups due to its huge potential for reducing metallic waste, reducing the cost of final printed parts and the interest in deriving additive manufacturing towards green, environmentally friendly technology. This Special Issue aims to publish high-quality papers on powder recycling for subsequent reuse cycles in 3D printing processes (laser powder built fusion) and on new methods for powder reconditioning and powder reuse strategies. This Special Issue targets the advanced development of authors and research groups focusing on new methods, new tools, and emerging approaches to reuse metallic powders in 3D printing and the new strategies for mixing the fresh and used powders in a way that aligns with the mechanical properties of the final printed parts. The new design of the parts and new powder surface treatment methods leading to reduced waste of leftover powder are accepted, and new system designs to enhance powder collection from the finished build cycles are also encouraged in this Special Issue.
Dr. Nima E. Gorji
Guest Editor
Manuscript Submission Information
Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.
Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Applied Sciences is an international peer-reviewed open access semimonthly journal published by MDPI.
Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2400 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.
Keywords
- powder recycling
- powder reconditioning
- 3D printing
- additive manufacturing
- powder reuse
- leftover powder
- reuse cyle
- laser powder build fusion
