Printed Microsensors and Applications
A special issue of Sensors (ISSN 1424-8220). This special issue belongs to the section "Nanosensors".
Deadline for manuscript submissions: closed (31 October 2023) | Viewed by 744
Special Issue Editor
Interests: high-rate nanomanufacturing; nanocontamination control; directed assembly of nanoelements; nanomanufacturing of nanoscale devices
Special Issue Information
Dear Colleagues,
Additive manufacturing and 3D printing technologies have recently demonstrated numerous improvements and innovations in making microsensors and microelectronics. Thus, it opens a new path of manufacturing for devices that previously were difficult to build, enabling, in addition, a wide array of applications in the fields of microsensors, microelectronics, and other nano and micro devices, among others. In addition, additive manufacturing reduces the cost by 10-100x as compared to conventional fabrication.
In the last few years, the printing processes improved significantly; however, advancements are constantly being made in materials used, manufacturing processes, and applications that may be displayed.
Therefore, this Special Issue mainly focuses on the printing technologies for microsensors, microelectronics and their applications in various industries.
Prof. Dr. Ahmed Busnaina
Guest Editor
Manuscript Submission Information
Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.
Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Sensors is an international peer-reviewed open access semimonthly journal published by MDPI.
Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2600 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.
Keywords
- printed microsensors
- printed microelectronics
- printing processes
- printing ink
- 3D printing of devices
