Failure, Fracture and Fatigue in Additive Manufacturing (F3AM)
A special issue of Journal of Manufacturing and Materials Processing (ISSN 2504-4494).
Deadline for manuscript submissions: closed (31 December 2021) | Viewed by 2917
Special Issue Editor
Special Issue Information
Dear Colleagues,
Additive manufacturing (AM), also known as 3D printing, has experienced dynamic and explosive growth in recent years in full-scale production of customized and/or complex parts. However, the development of AM is associated with ongoing challenges in static and dynamic failure (trustworthiness) of the AM parts relative to their conventionally fabricated forms. To be able to fully adopt AM technology in different engineering sectors (e.g., ground and air transportation, aerospace, defense, biomedical) the failure, fracture, and fatigue of AM parts, metallic and nonmetallic, must be fully assessed at ambient and elevated temperatures. This Special Issue of the Journal of Manufacturing and Materials Processing (JMMP) invites technical and review papers on, but not limited to, different aspects of damage in AM, including failure in various AM processes, static and dynamic failure and fracture, characterization of fracture and failure, metallurgy and materials science of failure, design against failure, integrity, modeling, and simulation of failure, creep, excessive deformation, wear, and case studies of failure and remedial actions.
Dr. Meysam Haghshenas
Guest Editor
Manuscript Submission Information
Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.
Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Journal of Manufacturing and Materials Processing is an international peer-reviewed open access semimonthly journal published by MDPI.
Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 1800 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.
Keywords
- additive manufacturing
- failure
- fracture
- fatigue
- integrity
- wear in additive manufacturing
- creep in additive manufacturing
- excessive deformation
- trustworthiness
- damage in additive manufacturing
