Development of Friction Stir Welding and Processing
A special issue of Coatings (ISSN 2079-6412). This special issue belongs to the section "Tribology".
Deadline for manuscript submissions: closed (10 November 2021) | Viewed by 4579
Special Issue Editor
Interests: welding and joining; coatings; light weight; mechanical properties; polymer matrix composites; materials fabrication; metal matrix composites
Special Issues, Collections and Topics in MDPI journals
Special Issue Information
Dear Colleagues,
Friction stir welding (FSW), a mature solid-state joining method, has become a revolutionary welding technique over the past two decades, due to its energy efficiency, environmental friendliness and high-quality joints. FSW is highly efficient in the joining of Al alloys, Mg alloys, Ti alloys, polymers and other dissimilar materials. Derived from FSW, friction stir processing (FSP) is a solid-state processing technique to fabricate and modify the bulk materials, composites and surface coatings, with tailored microstructures and enhanced mechanical properties, via severe plastic deformation and low temperature. Recently, FSW and FSP techniques have gained considerable scientific and technological attention in several fields, including aerospace, railway, renewable energy and automobile. Therefore, we expect that these fields may significantly contribute to accelerating the research and development in the areas of FSW and FSP.
This Special Issue focuses on new FSW/P technologies and basic investigations into the affecting factors and the underlying mechanisms for these technologies. The topics of interest for this Special Issue, in particular, include (but are not restricted to):
- Novel FSW technologies via assisted energy to improve quality and efficiency;
- Friction stir modifications of surfaces to generate functional surfaces for tribological, corrosion, and design properties;
- Fabrication of new multifunctional materials based on severe plastic deformation and low temperature;
- Joining of different material combinations and dissimilar materials with coatings to improve interfacial metallurgy and joining performance;
- Control strategies for inherent issues in FSW/P area;
- Additive manufacturing for adapted friction stir-based technologies;
- Any other aspects of novel FSW and FSP technologies.
Prof. Dr. Yongxian Huang
Guest Editor
Manuscript Submission Information
Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.
Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Coatings is an international peer-reviewed open access monthly journal published by MDPI.
Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2600 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.
Keywords
- friction stir welding
- friction stir processing
- additive manufacturing
- dissimilar materials
- composites
- coatings
