Next Article in Journal
Affective Recommender System for Pet Social Network
Next Article in Special Issue
Thermal Infrared Tracking Method Based on Efficient Global Information Perception
Previous Article in Journal
Prediction of the Physical Properties of a Structural Member by the Impact Hammer Test
Previous Article in Special Issue
YOLO-SASE: An Improved YOLO Algorithm for the Small Targets Detection in Complex Backgrounds
 
 
Article
Peer-Review Record

Thermal Water Prospection with UAV, Low-Cost Sensors and GIS. Application to the Case of La Hermida

Sensors 2022, 22(18), 6756; https://doi.org/10.3390/s22186756
by Javier Sedano-Cibrián *, Rubén Pérez-Álvarez, Julio Manuel de Luis-Ruiz, Raúl Pereda-García and Benito Ramiro Salas-Menocal
Reviewer 1:
Reviewer 2: Anonymous
Reviewer 3: Anonymous
Reviewer 4:
Sensors 2022, 22(18), 6756; https://doi.org/10.3390/s22186756
Submission received: 12 August 2022 / Revised: 2 September 2022 / Accepted: 5 September 2022 / Published: 7 September 2022
(This article belongs to the Special Issue Sensing and Processing for Infrared Vision: Methods and Applications)

Round 1

Reviewer 1 Report

The paper presents good idea ,but  the paper needs  some comments for publication as following:

1.Adapt and  rewrite the abstract

2.Enhancement the grammar of the paper

3.Make a lot of experiments

4. No comparison with prior arts.

5.Explain with details  the experimental results and analysis

6.Rewriting the Conclusion and add the future work.

 

7.Adapt the references

Comments for author File: Comments.pdf

Author Response

Please see the attachment.

Author Response File: Author Response.pdf

Reviewer 2 Report

Please check the attached file.

Comments for author File: Comments.pdf

Author Response

Please see the attachment.

Author Response File: Author Response.pdf

Reviewer 3 Report

The authors describe a case study (in La Hermida, Cantabria, Spain) in which geothermal resources are analysed by means of a field survey using an infrared sensor mounted on a UAV.   The article is well written and therefore I suggest publication after a few revisions.   - A summary of the regulations (not only in Spain) in the introduction could be useful to understand the applicability of the data processing presented also in other cases.   - The measurements for thermal calibration (Table 4) must be reported on the map. In addition, the deviation from the average could be indicated in the text.   - The map legends (figures 7,8,10) are to be reviewed, I guess the classes represent the temperature range and not single values. However, the limits in Figure 10 need to be changed for greater readability.   - Figure 14 is unclear, perhaps the authors should add the corresponding RGB image.   - Authors should discuss the reliability due to a single survey period, probably surveys in different periods or the comparison between day and night could provide more information.

Author Response

Please see the attachment.

Author Response File: Author Response.pdf

Reviewer 4 Report

 

 

 

Comments for author File: Comments.pdf

Author Response

Please see the attachment.

Author Response File: Author Response.pdf

Round 2

Reviewer 4 Report

Accept the paper

Back to TopTop