Biological Coatings for Buildings

A special issue of Coatings (ISSN 2079-6412).

Deadline for manuscript submissions: closed (31 July 2020) | Viewed by 702

Special Issue Editors


E-Mail Website
Guest Editor

E-Mail
Guest Editor
Mechanical Engineering Department, Engineering Faculty, Universidad del Norte, Barranquilla, Colombia
Interests: Sustainable Design; Eco-Design; Mechanical Systems Design

Special Issue Information

Dear Colleagues,

Due to the enormous energy and water demands from the rising number of buildings today, the development of biological coatings for buildings (biological concrete, green roofs and walls), which mainly reduce energy and water consumption, has become very attractive to government, industries, and scientists worldwide. For example, green roofs, multilayer coatings used on top of buildings, not only have the potential of increasing a building's thermal inertia but also to capture rainwater for reuse, this technology also can reduce the urban heat island effect, urban run-off water volumes, and noise and air pollution. However, in spite of the described benefits, the use of these technologies is still limited due to high investment and maintenance costs, and also to the lack of detailed technical information on the proper design and construction of these building coatings. Therefore, this Special Issue aims to provide better comparisons and assessments of the application potentials of different biological coating technologies on buildings. In particular, the topics of interest include, but are not limited to, the following aspects:

  • Mechanical, Thermal and Hydraulic Performance of Biological Coatings,

  • Modeling of Biological Coatings,

  • Life Cycle Assessment of Biological Coatings,

  • Construction of Biological Coatings and

  • Novel Biological Coatings.

Prof. Dr. Ir. Anibal Maury Ramirez
Prof. Dr. Ir. Heriberto Maury Ramirez
Guest Editors

Manuscript Submission Information

Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.

Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Coatings is an international peer-reviewed open access monthly journal published by MDPI.

Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2600 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.

Published Papers

There is no accepted submissions to this special issue at this moment.
Back to TopTop