Metrology for Living Environment and Comfort

A special issue of Buildings (ISSN 2075-5309). This special issue belongs to the section "Building Energy, Physics, Environment, and Systems".

Deadline for manuscript submissions: 25 July 2024 | Viewed by 390

Special Issue Editors


E-Mail Website
Guest Editor
1. Department of Computer Engineering, Modeling, Electronics and Systems Engineering (DIMES), University of Calabria, 87036 Rende, CS, Italy
2. CNR-NANOTEC, 87036 Rende, CS, Italy
Interests: measurements; distributed measurement systems; measurement and monitoring systems based on the IoT; measurement and monitoring systems based on AI; wireless sensor network; synchronization of measurement instruments and sensors; non-invasive measurements; non-destructive testing
Special Issues, Collections and Topics in MDPI journals

E-Mail Website
Guest Editor
Department of Industrial Engineering and Mathematical Sciences, Marche Polytechnic University, 60121 Ancona, Italy
Interests: well-being, environmental and comfort measurements; nondestructive testing; signal processing
Special Issues, Collections and Topics in MDPI journals

E-Mail Website
Guest Editor
Department of Informatics, Modeling, Electronics and System Engineering, The University of Calabria, 87036 Rende, CS, Italy
Interests: nondestructive testing; ultrasonics; acoustic metamaterials; phonic crystals; signal and image processing
Special Issues, Collections and Topics in MDPI journals

E-Mail Website
Guest Editor
Department of Electronics, School of Engineering, University of Alcala, Campus Universitario s/n, E-28805 Alcala de Henares, Madrid, Spain
Interests: ultrasonic sensory systems; local positioning systems (LPSs); embedded systems; electronic design
Special Issues, Collections and Topics in MDPI journals

Special Issue Information

Dear Colleagues,

Humans spend up to 80% of their lives in built and living environments. New technological research focuses on the design, implementation, and development of both built and living environments considering the occupants’ needs, well-being, and surroundings, as well as climate change impacts and energy-saving solutions. In light of these trends, this Special Issue welcomes papers presenting innovative metrology techniques for designing, constructing, and operating an efficient, safe, comfortable, and healthy built environment, including active and assisted living (AAL). Innovative solutions can be based on the IoT paradigm, BIM, sensors and sensor networks, cutting-edge signal and image processing, structural health monitoring (SHM) techniques, data analytics, artificial intelligence, and interoperability standards.

Dr. Francesco Lamonaca
Dr. Sara Casaccia
Dr. Stefano Laureti
Dr. Álvaro Hernández Alonso
Guest Editors

Manuscript Submission Information

Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.

Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Buildings is an international peer-reviewed open access monthly journal published by MDPI.

Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2600 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.

Keywords

  • wellbeing of people in living environments
  • measurement of comfort in indoor environments
  • active and assisted living
  • sensors and sensor networks
  • signal and image processing
  • structural health monitoring
  • artificial intelligence for living environments
  • BIM
  • monitoring of chemical and physical parameters
  • IoT
  • human health monitoring

Published Papers

This special issue is now open for submission.
Back to TopTop