Next Article in Journal
Optimizing Experimental Immersion Protocol for SEBS Coating Formation on Copper Surfaces Using Response Surface Methodology
Next Article in Special Issue
Initial Vacancy-Dependent High-Temperature Creep Behavior of Nanocrystalline Ni by Molecular Dynamics Simulation
Previous Article in Journal
Sintering Behavior, Microstructure and Microwave Dielectric Properties of Li2TiO3-Based Solid Solution Ceramics with Lithium Fluoride Addition for Low-Temperature Co-Fired Ceramic Applications
Previous Article in Special Issue
Enterosorbents Based on Rhubarb Biomass with a Hybrid Polymer-Inorganic Coating for the Immobilization of Azaheterocyclic Mycotoxins
 
 
Communication
Peer-Review Record

Integration of Passivated Gold Mirrors into Microfabricated Alkali Vapor Cells

Coatings 2023, 13(10), 1733; https://doi.org/10.3390/coatings13101733
by Florian Wittkämper *, Theo Scholtes, Sven Linzen, Mario Ziegler and Ronny Stolz
Reviewer 1: Anonymous
Reviewer 2: Anonymous
Reviewer 3: Anonymous
Coatings 2023, 13(10), 1733; https://doi.org/10.3390/coatings13101733
Submission received: 31 August 2023 / Revised: 29 September 2023 / Accepted: 30 September 2023 / Published: 4 October 2023

Round 1

Reviewer 1 Report

The authors theoretically studied the integration of passivated gold mirrors into microfabricated alkali vapor cells. This work is interesting and has potential applications in alkali vapor cells for optically pumped magnetometers (OPMs). I would like to recommend this manuscript for publication, after the following concerns are addressed properly.

[1] The text in the left part of Figure 6 is not clear, which is hard to be seen clearly. So, I suggest the authors to change properly the font size.

[2] It is not necessary to define again the abbreviation of OPMs in the Line 26. The abbreviation has been defined in the abstract part.

[3] In Lines 46, 108, 124, 133, and137, there are two full points behind the word “found”. One of them should be deleted.

[4] I don't understand why the following sentence occurs frequently in the text:

   In Error! Reference source not found.

[5] From Line 149 to Line 160, the sentences are disorganized and cannot be understood.

Author Response

Please see the attachment.

Author Response File: Author Response.pdf

Reviewer 2 Report

Manuscript review No:  coatings-2613435

 Title: Integration of passivated gold mirrors into microfabricated alkali vapor cells

 Authors: Florian Wittkämper, Theo Scholtes, Sven Linzen, Mario Ziegler, Ronny Stolz

 A. Overview

1. In this manuscript the authors propose a new technique for addition of passivated gold mirrors into vapor cells.

 2. The contents are expressed clearly; the manuscript is well organized, and it is written in reasonable English.

Though, reading of the manuscript is required as several misprints (such as Error! Reference source not found.. ) and grammar issues ca be found in the manuscript.

 3. The authors have acknowledged recent research on this topic.

 4. As long as my knowledge, the work presented is original. However, is not a remarkable new issue.

 B. Detailed analysis.

Abstract: too lengthy must be clear and objective. State briefly what you did, how did you do it, the quantitative results you and state clearly the novelty of your work.

 1. INTRODUCTION: provides an interesting approach to the subject and there are up to date references.

 C. Overall assessment

The work presented here is very interesting and has potential for further developments.

In my opinion the manuscript can be accepted for publication after minor revision.

D. Review Criteria

1. Scope of Journal

Rating: Medium

2. Novelty and Impact

Rating: LOW

3. Technical Content

Rating: Medium

4. Presentation Quality

Rating: Medium

 

The contents are expressed clearly; the manuscript is well organized, and it is written in reasonable English.

Though, reading of the manuscript is required as several misprints (such as Error! Reference source not found.. ) and grammar issues ca be found in the manuscript.

Author Response

Please see the attachment.

Author Response File: Author Response.pdf

Reviewer 3 Report

Dear Authors,

Your article is written carelessly. It appears that you have not read the PDF file offered for review.

Please find comments to the manuscript in the attached PDF file, as sticky notes.

Kind regards.

Comments for author File: Comments.pdf

Minor editing of English language required.

Author Response

Please see the attachment.

Author Response File: Author Response.pdf

Round 2

Reviewer 1 Report

All my questions have been addressed properly, and this work can be accepted for publication.

Author Response

.

Reviewer 3 Report

Dear Authors,

Despite neither in the abstract nor in the introduction you have not explained why did you use caesium in your device, your manuscript could be published.

Kind regards.

Minor editing of English language required.

Author Response

Please see the attachement.

Author Response File: Author Response.pdf

Back to TopTop