Special Issue "Micromachined Flow Sensors"
A special issue of Sensors (ISSN 1424-8220). This special issue belongs to the section "Physical Sensors".
Deadline for manuscript submissions: closed (1 September 2019) | Viewed by 3579
Special Issue Editors
Interests: mechanical microsensors; electronic interfacing of sensors; sensor packaging; force sensors; flow sensors; inertial sensors
Special Issues, Collections and Topics in MDPI journals
2. Bronkhorst High-Tech BV, Nijverheidsstraat 1A, 7261 AK Ruurlo, The Netherlands
Interests: design, modeling, fabrication and application of microfluidic handling systems; MEMS thermal and Coriolis flow sensors and controllers; MEMS pressure sensors; MEMS control valves; micromachined flow analysis systems; multiparameter flow measurement systems; micro Wobbe index meters
Special Issues, Collections and Topics in MDPI journals
Special Issue Information
Dear Colleagues,
Since the publication of the first micromachined flow sensors in the 1970s, there has been a tremendous development. Whereas the first sensors were mostly based on thermal sensing principles, we now see a large range of different operating principles: Thermal, anemometric, calorimetric, time-of-flight, measuring pressure drop along a channel or over an orifice, measuring drag force at a channel wall or on an obstacle in the flow, and, more recently, also sensors based on Coriolis forces and ultrasonic measurements. Combining different sensor principles on a single chip allows the measurement of fluid parameters, such as density and viscosity. With increasingly smaller flow levels, the characterization and calibration of sensors also becomes a challenge.
This Special Issue covers the recent advances in all aspects of micro flow sensor research, including design and fabrication of the sensor chips, physical working principles, modeling and simulation, and the measurement setups for their characterization and calibration.
Dr. Remco Wiegerink
Prof. Dr. Joost Lötters
Guest Editors
Manuscript Submission Information
Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.
Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Sensors is an international peer-reviewed open access semimonthly journal published by MDPI.
Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2600 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.
Keywords
- Flow sensors
- Fluid parameter sensors
- Flow sensor characterization and calibration
- Measurement of extremely small flows
