Polymers 2023, 15(6), 1367; https://doi.org/10.3390/polym15061367 - 09 Mar 2023
Cited by 1 | Viewed by 828
Abstract
►
Show Figures
Anything that is not recycled and/or recovered from waste represents a loss of raw materials. Recycling plastics can help to reduce this loss and to reduce greenhouse gases, improving the goal of the decarbonization of plastic. While the recycling of single polymers is
[...] Read more.
Anything that is not recycled and/or recovered from waste represents a loss of raw materials. Recycling plastics can help to reduce this loss and to reduce greenhouse gases, improving the goal of the decarbonization of plastic. While the recycling of single polymers is well assessed, the recycling of mixed plastics is very difficult because of the strong incompatibility among the different polymers usually present in urban waste. In this work, heterogeneous mixed polymers, i.e., polyethylene (PE), polypropylene (PP), polystyrene (PS) and polyethylenetherephthalate (PET) were processed using a laboratory mixer under different conditions of temperature, rotational speed and time to evaluate the effect of the above parameters on morphology, viscosity and mechanical properties of the final blends. Morphological analysis shows a strong incompatibility between the polyethylene matrix and the other dispersed polymers. The blends show, of course, a brittle behavior, but this behavior slightly improves with decreasing temperature and increasing rotational speed. A brittle-ductile transition was observed only at a high level of mechanical stress obtained by increasing rotational speed and decreasing temperature and processing time. This behavior has been attributed to both a decrease in the dimensions of the particles of the dispersed phase and to the formation of a small amount of copolymers that act as adhesion promoters between matrix and dispersed phases.
Full article
Graphical abstract
