Search for Articles:
Title / Keyword
Author / Affiliation / Email
Journal
Article Type
 
 
Advanced Search
 
Section
Special Issue
Volume
Issue
Number
Page
 
4.8
2.4
Journals
Colloids and Interfaces
Special Issues
Feature Reviews in Colloids, Nanomaterials, and Interfaces
share announcement

Feature Reviews in Colloids, Nanomaterials, and Interfaces

A special issue of Colloids and Interfaces (ISSN 2504-5377).

Deadline for manuscript submissions: closed (30 September 2022) | Viewed by 16974

Special Issue Editors

Dr. Alexander Kamyshny

E-Mail Website
Guest Editor
Casali Center for Applied Chemistry, Institute of Chemistry, Faculty of Mathematics and Sciences, The Hebrew University of Jerusalem, Jerusalem, Israel
Interests: colloidal systems; nanomaterials; conductive inks; printed electronics
Special Issues, Collections and Topics in MDPI journals
Prof. Dr. Victor Starov

E-Mail Website
Guest Editor
Chemical Engineering Department, Loughborough University, Loughborough, UK
Interests: colloid and interface science; kinetics of wetting and spreading
Special Issues, Collections and Topics in MDPI journals

Special Issue Information

Dear Colleagues,

In this Special Issue, various aspects of colloid and interface science as well as nanomaterials are considered. A significant part of this Issue is focused on topics related to research performed in the framework of Marie Skłodowska-Curie Innovative Training Networks, which are one of the most important sources of scientific funding in the European community and partner countries. The NanoPaint project was funded in the beginning of 2021 for four consecutive years and includes 14 partners from all over EU, as well as from the UK and Israel. The project organiser is Professor Tatiana Gambaryan-Roisman, Darmstadt University, Germany. Both Co-Editors of the Special Issue (Alexander Kamyshny, Israel, and Victor Starov, UK) are participants of the nanoPaint project.

Dr. Alexander Kamyshny
Prof. Dr. Victor Starov
Guest Editors

Manuscript Submission Information

Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.

Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Colloids and Interfaces is an international peer-reviewed open access semimonthly journal published by MDPI.

Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 1600 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.

Keywords

  • experimental and theoretical aspects of interfacial phenomena colloidal systems—suspensions, emulsions, foams, gels, ionic liquids
  • properties of colloidal systems such as rheology and material properties
  • nanomaterials: synthesis, characterization, and application
  • properties of solutions of surface-active molecules—molecular surfactants as well as macromolecular surface-active substances
  • self-assembling phenomena and aggregates in solution (micelles and liquid crystals) and at interfaces
  • fluid dynamics, multi-phase flows, and other related fields
  • application of colloids and interfacial aspects in chemistry, biology, and medicine, as well as in industrial areas such as cosmetics, materials science, polymers, food, and pharmacy
  • new emerging directions in colloid and interface science

Published Papers (5 papers)

Download All Papers
Order results
Result details
Show export options expand_more Show export options expand_less
Select all
Export citation of selected articles as:

Review

18 pages, 1823 KiB  
Review
Dynamic Light Scattering: A Powerful Tool for In Situ Nanoparticle Sizing
by Zixian Jia, Jiantao Li, Lin Gao, Dezheng Yang and Andrei Kanaev
Colloids Interfaces 2023, 7(1), 15; https://doi.org/10.3390/colloids7010015 - 16 Feb 2023
Cited by 24 | Viewed by 6946
Abstract
Due to surface effects and quantum size effects, nanomaterials have properties that are vastly different from those of bulk materials due to surface effects. The particle size distribution plays an important role in chemical and physical properties. The measurement and control of this [...] Read more.
Due to surface effects and quantum size effects, nanomaterials have properties that are vastly different from those of bulk materials due to surface effects. The particle size distribution plays an important role in chemical and physical properties. The measurement and control of this parameter are crucial for nanomaterial synthesis. Dynamic light scattering (DLS) is a fast and non-invasive tool used to measure particle size, size distribution and stability in solutions or suspensions during nanomaterial preparation. In this review, we focus on the in situ sizing of nanomaterial preparation in the form of colloids, especially for metal oxide nanoparticles (MONs). The measuring principle, including an overview of sizing techniques, advantages and limitations and theories of DLS were first discussed. The instrument design was then investigated. Ex-situ and in situ configuration of DLS, sample preparations, measurement conditions and reaction cell design for in situ configuration were studied. The MONs preparation monitored by DLS was presented, taking into consideration both ex situ and in situ configuration. Full article
(This article belongs to the Special Issue Feature Reviews in Colloids, Nanomaterials, and Interfaces)
►▼ Show Figures

Figure 1

19 pages, 808 KiB  
Review
Marangoni Patterns in a Non-Isothermal Liquid with Deformable Interface Covered by Insoluble Surfactant
by Alexander B. Mikishev and Alexander A. Nepomnyashchy
Colloids Interfaces 2022, 6(4), 53; https://doi.org/10.3390/colloids6040053 - 29 Sep 2022
Cited by 1 | Viewed by 1638
Abstract
Marangoni patterns are created by instabilities caused by thermocapillary and solutocapillary stresses on the deformable free surface of a thin liquid layer. In the present paper, we consider the influence of the insoluble surfactant on the selection and modulational instability of stationary Marangoni [...] Read more.
Marangoni patterns are created by instabilities caused by thermocapillary and solutocapillary stresses on the deformable free surface of a thin liquid layer. In the present paper, we consider the influence of the insoluble surfactant on the selection and modulational instability of stationary Marangoni patterns near their onset threshold. The basic governing parameters of the problem are the Biot number characterizing the heat-transfer resistances of and at the surface, the Galileo number indicating the role of gravity via viscous forces, and the elasticity number specifying the influence of insoluble surfactant on the interfacial dynamics of the liquid. The paper includes a review of the previous results obtained in that problem as well as new ones. Full article
(This article belongs to the Special Issue Feature Reviews in Colloids, Nanomaterials, and Interfaces)
►▼ Show Figures

Figure 1

7 pages, 1966 KiB  
Review
The Contact Angle Hysteresis Puzzle
by Abraham Marmur
Colloids Interfaces 2022, 6(3), 39; https://doi.org/10.3390/colloids6030039 - 04 Jul 2022
Cited by 7 | Viewed by 2293
Abstract
This short review explains the essence of the theory of contact angle hysteresis. It emphasizes the controversial points and discusses the shortcomings of contact angle hysteresis measurements. The review ends with conclusions regarding the improvements that are required to make these measurements useful [...] Read more.
This short review explains the essence of the theory of contact angle hysteresis. It emphasizes the controversial points and discusses the shortcomings of contact angle hysteresis measurements. The review ends with conclusions regarding the improvements that are required to make these measurements useful for the characterization of surface wettability. Full article
(This article belongs to the Special Issue Feature Reviews in Colloids, Nanomaterials, and Interfaces)
►▼ Show Figures

Figure 1

14 pages, 2235 KiB  
Review
Interfacial Flows and Interfacial Shape Modulation Controlled by the Thermal Action of Light Energy
by Natalia Ivanova
Colloids Interfaces 2022, 6(2), 31; https://doi.org/10.3390/colloids6020031 - 13 May 2022
Cited by 3 | Viewed by 2181
Abstract
The review covers the research on thermocapillary convection caused by the thermal action of laser radiation in single-layer and bilayer liquid systems of capillary thickness. The advantages of using optical radiation are the instantaneous delivery of thermal energy to a place on demand [...] Read more.
The review covers the research on thermocapillary convection caused by the thermal action of laser radiation in single-layer and bilayer liquid systems of capillary thickness. The advantages of using optical radiation are the instantaneous delivery of thermal energy to a place on demand (a bulk phase, interfaces); low radiation power required; concentrating heat flux on a spot of a few micrometers; the production of arbitrary spatial distributions of radiation intensity; and, as a result, corresponding thermal fields at a liquid interface and their fast reconfiguration. Thermocapillary stresses at the liquid interfaces lead to the transfer of the liquid and a change in the shape of the interface, in accordance with the distribution of the light-induced thermal field. Studies concerned with the methods of non-destructive testing of liquid media and solids, which are based on a photothermocapillary signal emitted by a laser-induced concave deformation of a thin layer, are considered. Features of thermocapillary deformation of a liquid–air interface caused by local heating of thin and thick (exceeding the capillary length) layers are demonstrated. A part of the review addresses the results of the study of thermocapillary rupture of films in the heating zone and the application of this effect in semiconductor electronics and high-resolution lithography. The works on the light-induced thermocapillary effect in bilayer (multilayer) liquid systems are analyzed, including early works on image recording liquid layer systems, liquid IR transducers, and nonlinear optical media. Full article
(This article belongs to the Special Issue Feature Reviews in Colloids, Nanomaterials, and Interfaces)
►▼ Show Figures

Figure 1

22 pages, 2066 KiB  
Review
Triazine 2D Nanosheets as a New Class of Nanomaterials: Crystallinity, Properties and Applications
by Valery N. Zakharov, Igor K. Kudryavtsev, Sergey F. Dunaev, Kseniya A. Paseshnichenko and Leonid A. Aslanov
Colloids Interfaces 2022, 6(2), 20; https://doi.org/10.3390/colloids6020020 - 30 Mar 2022
Cited by 3 | Viewed by 2931
Abstract
Based on the recent (2015–2021) literature data, the authors analyze the mutual dependence of crystallinity/amorphism and specific surface area and porosity in covalent triazine frameworks (CTFs), taking into account thermodynamic and kinetic control in the synthesis of these 2D nanosheets. CTFs have now [...] Read more.
Based on the recent (2015–2021) literature data, the authors analyze the mutual dependence of crystallinity/amorphism and specific surface area and porosity in covalent triazine frameworks (CTFs), taking into account thermodynamic and kinetic control in the synthesis of these 2D nanosheets. CTFs have now become a promising new class of high-performance porous organic materials. They can be recycled and reused easily, and thus have great potential as sustainable materials. For 2D CTFs, numerous examples are given to support the known rule that the structure and properties of any material with a given composition depend on the conditions of its synthesis. The review may be useful for elder students, postgraduate students, engineers and research fellows dealing with chemical synthesis and modern nanotechnologies based on 2D covalent triazine frameworks. Full article
(This article belongs to the Special Issue Feature Reviews in Colloids, Nanomaterials, and Interfaces)
►▼ Show Figures

Figure 1

Show export options expand_more Show export options expand_less
Select all
Export citation of selected articles as:
 
Displaying articles 1-5
Back to TopTop