Novel Fiber-Based Scaffolds for Tissue Engineering and Regenerative Medicine

A special issue of Bioengineering (ISSN 2306-5354). This special issue belongs to the section "Regenerative Engineering".

Deadline for manuscript submissions: 31 May 2024 | Viewed by 189

Special Issue Editors

Department of Biomedical Engineering, University of Connecticut Health Center L7073, Farmington, CT 06030, USA
Interests: tissue engineering; biomaterials; drug delivery; microfluidics; biofabrication; biomedical devices
Special Issues, Collections and Topics in MDPI journals

Special Issue Information

Dear Colleagues,

We are preparing a Special Issue on “Novel fiber-based scaffolds for tissue engineering and regenerative medicine" to be published in Bioengineering. Tissue-engineered scaffolds aim to recapitulate the physiological environment of the extracellular matrix in vivo. This enables biomimetic mechanical and structural properties; proper transport of oxygen, nutrients, and metabolic waste; and, therefore, improved cellular behavior when exposed to the scaffold. Fiber-based scaffolds fabricated through spinning (electrospinning, centrifugal spinning, wet-spinning, melt-spinning, etc.), extrusion-based printing, and molding have attracted increasing attention in the last decade to address the above-mentioned requirements for bottom-up tissue reconstruction. Importantly, the control of the fiber fabrication and assembly approaches offers desired scaffold microstructure and anisotropy for the engineering of various tissues. Therefore, novel fiber-based scaffold fabrication approaches and biomaterial precursors, compatible with both the fabrication process and tissue culture, are needed for the reconstruction of functional tissue. 

The current Special Issue is focused on the recent advancements in the development of strategies for the fabrication of fiber-based scaffolds and their application for tissue engineering and regenerative medicine. Specifically, we aim to cover novel approaches enabling a controlled scaffold microstructure, multimaterial spatial distribution, and in vivo fabrication processes. Furthermore, the application of engineered tissues using fiber-based scaffolds for in vitro tissue modeling, regenerative medicine, and emerging fields such as cellular agriculture will be covered in this issue.

Dr. Mohamadmahdi Samandari
Dr. Mohsen Akbari
Guest Editors

Manuscript Submission Information

Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.

Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Bioengineering is an international peer-reviewed open access monthly journal published by MDPI.

Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2700 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.

Keywords

  • tissue engineering
  • regeneration
  • electrospinning
  • 3D (bio)printing
  • wet spinning
  • in vivo scaffold fabrication

Published Papers

This special issue is now open for submission.
Back to TopTop