# Research on Solid Oxide Fuel Cell System Model Building and 3D Testing Based on the Nodal Idea

^{1}

^{2}

^{3}

^{4}

^{*}

^{†}

## Abstract

**:**

## 1. Introduction

#### 1.1. SOFC Power Generation Principle and Characteristics

#### 1.2. SOFC Modeling at Home and Abroad

## 2. SOFC Model Building

#### 2.1. SOFC System Composition

#### 2.2. Modeling Methods and Processes

#### 2.2.1. General Model Equation

- (1)
- All the gases involved meet the ideal gas equation of state.
- (2)
- All characteristic parameters of the gas are uniformly distributed during gas flow.
- (3)
- The SOFC system is absolutely independent and sealed, and there is no heat transfer with the external environment.
- (4)
- There is no material accumulation and precipitation in the reactor, combustion chamber, or other devices.
- (5)
- The SOFC has a 100% current efficiency rate.
- (6)
- The hysteresis characteristics of the gas in each gas supply pipeline are replaced with an inertia link and a delay link.

- (1)
- Temperature characteristics

- (2)
- Velocity characteristics

- (3)
- Mole fraction properties

#### 2.2.2. Model of Each System Component

- (1)
- Heat exchanger model

- (2)
- Reactor model

- (3)
- Combustion chamber model

- (4)
- Lag model of the gas supply system

#### 2.3. Integration of SOFC Models

## 3. SOFC Performance Testing and Verification

#### 3.1. SOFC Performance Indicators

#### 3.1.1. Operation Parameters and Their Ranges

- (1)
- Fuel utilization rate ($FU$).$$FU=\frac{{R}_{{\mathrm{H}}_{2}}}{{\dot{N}}_{{\mathrm{H}}_{2}}}=\frac{n{I}_{s}}{2F{\dot{N}}_{{\mathrm{H}}_{2}}}.$$

- (2)
- Air excess ratio ($AR$).$$AR=\frac{{\dot{N}}_{{\mathrm{O}}_{2}}}{{R}_{{\mathrm{O}}_{2}}}=\frac{4F{X}_{{\mathrm{O}}_{2}}{\dot{N}}_{air}}{n{I}_{s}}.$$

- (3)
- Bypass valve opening ($BP$).$$BP=\frac{{\dot{N}}_{air,by}}{{\dot{N}}_{air}}.$$

- (4)
- Reactor current (${I}_{s}$):

#### 3.1.2. SOFC Static Performance Tests

#### 3.2. Thermal Output Characteristics and Their Ranges

#### 3.2.1. Thermal Output Characteristic Parameters

- (1)
- Maximum operating temperature of PEN($Max.{T}_{PEN}$).

- (2)
- Maximum operating temperature gradient of PEN($Max.|\Delta {T}_{PEN}|$).

- (3)
- Gas temperature difference at the reactor inlet ($\Delta {T}_{inlet}$):

- (4)
- Combustion chamber temperature (${T}_{B}$).

#### 3.2.2. One-Dimensional Test and Verification of Heat Output Characteristics

#### 3.2.3. Two-Dimensional Test and Verification of Heat Output Characteristics

#### 3.2.4. Three-Dimensional Test and Verification of Heat Output Characteristics

#### 3.3. Electrical Output Characteristics and Their Ranges

#### 3.3.1. Electrical Output Characteristic Parameters

^{−1}.

#### 3.3.2. One-Dimensional Test and Verification of Electrical Output Characteristics

#### 3.3.3. Two-Dimensional Test and Verification of Electrical Output Characteristics

#### 3.3.4. Three-Dimensional Test and Verification of Electrical Output Characteristics

## 4. Conclusions

## Author Contributions

## Funding

## Conflicts of Interest

## References

- Wang, Z.L. Energy crisis in the post-petroleum era. Resour. Hum. Settl.
**2008**, 9, 34–36. [Google Scholar] - Peng, H.; Behnam, S. Application of the improved chaotic grey wolf optimization algorithm as a novel and efficient method for parameter estimation of solid oxide fuel cells model. Int. J. Hydrogen Energy
**2021**, 46, 36454–36465. [Google Scholar] - Wang, L.S.; Ying, L. Fuel Cell, 2nd ed.; Metallurgical Industry Press: Beijing, China, 2005. [Google Scholar]
- Yi, L.B. Fuel Cell: Efficient and Environmentally Friendly Power Generation; Chemical Industry Press: Beijing, China, 2000. [Google Scholar]
- McLarty, D.; Brouwer, J.; Samuelsen, S. A spatially resolved physical model for transient system analysis of high temperature fuel cells. Int. J. Hydrogen Energy
**2013**, 38, 7935–7946. [Google Scholar] [CrossRef][Green Version] - Aguiar, P.; Adjiman, C.S.; Brandon, N.P. Anode-supported intermediate temperature direct internal reforming solid oxide fuel cell. I: Model-based steady-state performance. J. Power Sources
**2004**, 138, 120–136. [Google Scholar] - Gemmen, R.S.; Johnson, C.D. Effect of load transients on SOFC operation: Current reversal on loss of load. J. Power Sources
**2005**, 144, 152–164. [Google Scholar] - Achenbach, E. Three-dimensional and time-dependent simulation of a planar solid oxide fuel cell stack. J. Power Sources
**1994**, 49, 333–348. [Google Scholar] - Hofmann, P.; Panopoulos, K.D. Detailed dynamic Solid Oxide Fuel Cell modeling for electrochemical impedance spectra simulation. J. Power Sources
**2010**, 195, 5320–5339. [Google Scholar] [CrossRef] - Campanari, S.; Iora, P. Comparison of finite volume SOFC models for the simulation of a planar cell geometry. Fuel Cells
**2005**, 5, 34–51. [Google Scholar] [CrossRef] - Ota, T.; Koyama, M.; Wen, C.; Yamada, K.; Takahashi, H. Object-based modeling of SOFC system: Dynamic behavior of micro-tube SOFC. J. Power Sources
**2003**, 118, 430–439. [Google Scholar] [CrossRef] - Iora, P.; Aguiar, P.; Adjiman, C.S.; Brandon, N.P. Comparison of two IT DIR-SOFC models: Impact of variable thermodynamic, physical, and flow properties. Steady-state and dynamic analysis. Chem. Eng. Sci.
**2005**, 60, 2963–2975. [Google Scholar] - Park, J.; Li, P.; Bae, J. Analysis of chemical, electrochemical reactions and thermo-fluid flow in methane-feed internal reforming SOFCs: Part I—Modeling and effect of gas concentrations. Int. J. Hydrogen Energy
**2012**, 37, 8512–8531. [Google Scholar] - Pregelj, B.; Vrečko, D.; Petrovčič, J.; Jovan, V.; Dolanc, G. A model-based approach to battery selection for truck onboard fuel cell-based APU in an anti-idling application. Appl. Energy
**2015**, 137, 64–76. [Google Scholar] [CrossRef] - Murshed, A.K.; Huang, B.; Nandakumar, K. Control relevant modeling of planer solid oxide fuel cell system. J. Power Sources
**2007**, 163, 830–845. [Google Scholar] - Adhikari, P.; Abdelrahman, M. Modeling, Control, and Integration of a Portable Solid Oxide Fuel Cell System. J. Fuel Cell Sci. Technol.
**2012**, 9, 11010–11014. [Google Scholar] [CrossRef] - Mueller, F.; Brouwer, J.; Jabbari, F.; Samuelsen, S. Dynamic Simulation of an Integrated Solid Oxide Fuel Cell System Including Current-Based Fuel Flow Control. J. Fuel Cell Sci. Technol.
**2006**, 3, 144–154. [Google Scholar] - Zabaniotou, A. Agro-residues implication in decentralized CHP production through a thermochemical conversion system with SOFC. Sustain. Energy Technol. Assess.
**2014**, 6, 34–50. [Google Scholar] - Fardadi, M.; Mueller, F.; Jabbari, F. Feedback control of solid oxide fuel cell spatial temperature variation. J. Power Sources
**2010**, 195, 4222–4233. [Google Scholar] [CrossRef] - Sorrentino, M.; Pianese, C. Model-based development of low-level control strategies for transient operation of SOFC systems. J. Power Sources
**2011**, 196, 9036–9045. [Google Scholar] [CrossRef] - Lanzini, A.; Leone, P. Experimental investigation of direct internal reforming of biogas in solid oxide fuel cells. Int. J. Hydrogen Energy
**2010**, 35, 2463–2476. [Google Scholar] [CrossRef] - Kazempoor, P.; Dorer, V.; Ommi, F. Evaluation of hydrogen and methane-fuelled solid oxide fuel cell systems for residential applications: System design alternative and parameter study. Int. J. Hydrogen Energy
**2009**, 34, 8630–8644. [Google Scholar] - Sembler, W.J.; Kumar, S. Optimization of a Single-Cell Solid-Oxide Fuel Cell Using Computational Fluid Dynamics. J. Fuel Cell Sci. Technol.
**2011**, 8, 21007–21012. [Google Scholar] - Xi, H. Dynamic Modeling and Control of Planar SOFC Power Systems; The University of Michigan: Ann Arbor, MI, USA, 2007. [Google Scholar]
- Jiang, J.H. Dynamic Modeling and Control of Plate Solid Oxide Fuel Cell System; Huazhong University of Science and Technology Library: Wuhan, China, 2013. (In Chinese) [Google Scholar]
- Mueller, F. The Dynamics and Control of Integrated Solid Oxide Fuel Cell Systems: Transient Load Following and Disturbance Rejection; University of California: Irvine, CA, USA, 2008. [Google Scholar]
- Larminie, J.; Dicks, A. Fuel Cell Systems Explained, 2nd ed.; John Wiley & Sons Ltd.: Chichester, UK, 2003. [Google Scholar]
- Cao, H.L. Dynamic Modeling and Control of Solid Oxide Fuel Cell Power Generation System; Huazhong University of Science and Technology Library: Wuhan, China, 2012. [Google Scholar]
- He, W.; Wang, B.; Zhao, H.; Jiao, Y. Doubling the diffusivity measurement efficiency in solid oxide fuel cells (SOFCs) via a bi-sensor electrochemical cell. J. Power Sources
**2011**, 23, 9985–9998. [Google Scholar] - Lu, N.; Li, Q.; Sun, X.; Khaleel, M.A. The modeling of a standalone solid-oxide fuel cell auxiliary power unit. J. Power Sources
**2006**, 161, 938–948. [Google Scholar] - Mueller, F.; Fardadi, M.; Shaffer, B.; Brouwer, J.; Jabbari, F. Transient Performance of Integrated SOFC System Including Spatial Temperature Control. In Proceedings of the ASME 2010 Eighth International Fuel Cell Science, Engineering and Technology Conference, Brooklyn, NY, USA, 14–16 June 2010. [Google Scholar]
- Ni, M.; Leung, D.Y.; Leung, M.K. Electrochemical modeling and parametric study of methane fed solid oxide fuel cells. Energy Convers. Manag.
**2009**, 50, 268–278. [Google Scholar] - Zhang, L. Optimization and Control of SOFC System for High Efficiency Load Tracking; Huazhong University of Science and Technology Library: Wuhan, China, 2015. [Google Scholar]
- Zabihian, F.; Fung, A.S. Thermodynamic sensitivity analysis of hybrid system based on solid oxide fuel cell. Sustain. Energy Technol. Assess.
**2014**, 6, 51–59. [Google Scholar]

**Figure 5.**Validation of SOFC experiments (E) against model simulations and (S) through curve fitting.

Disclaimer/Publisher’s Note: The statements, opinions and data contained in all publications are solely those of the individual author(s) and contributor(s) and not of MDPI and/or the editor(s). MDPI and/or the editor(s) disclaim responsibility for any injury to people or property resulting from any ideas, methods, instructions or products referred to in the content. |

© 2023 by the authors. Licensee MDPI, Basel, Switzerland. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution (CC BY) license (https://creativecommons.org/licenses/by/4.0/).

## Share and Cite

**MDPI and ACS Style**

Li, M.; Zhu, K.; Rao, M.; Chen, Z.; Xiong, K.; Hou, L.; Wang, X.; Chen, C.; Li, S.; Li, X.
Research on Solid Oxide Fuel Cell System Model Building and 3D Testing Based on the Nodal Idea. *Atmosphere* **2023**, *14*, 1261.
https://doi.org/10.3390/atmos14081261

**AMA Style**

Li M, Zhu K, Rao M, Chen Z, Xiong K, Hou L, Wang X, Chen C, Li S, Li X.
Research on Solid Oxide Fuel Cell System Model Building and 3D Testing Based on the Nodal Idea. *Atmosphere*. 2023; 14(8):1261.
https://doi.org/10.3390/atmos14081261

**Chicago/Turabian Style**

Li, Mingfei, Kanglin Zhu, Mumin Rao, Zhengpeng Chen, Kai Xiong, Longtong Hou, Xiabin Wang, Chuangting Chen, Shujun Li, and Xi Li.
2023. "Research on Solid Oxide Fuel Cell System Model Building and 3D Testing Based on the Nodal Idea" *Atmosphere* 14, no. 8: 1261.
https://doi.org/10.3390/atmos14081261