Sensors

615 KiB

Open AccessArticle

Polystyrene Based Silver Selective Electrodes

by Vinod Kumar Gupta, Milan V Antonijevic, Sudeshna Chandra and Shiva Agarwal

Sensors 2002, 2(6), 233-243; https://doi.org/10.3390/s20600233 - 24 Jun 2002

Cited by 23 | Viewed by 9304

Silver(I) selective sensors have been fabricated from polystyrene matrix membranes containing macrocycle, Me₆(14) diene.2HClO₄ as ionophore. Best performance was exhibited by the membrane having a composition macrocycle : Polystyrene in the ratio 15:1. This membrane worked well over a wide concentration range 5.0×10^-6–1.0×10^-1M of Ag⁺ with a near-Nernstian slope of 53.0 ± 1.0 mV per decade of Ag⁺ activity. The response time of the sensor is <15 s and the membrane can be used over a period of four months with good reproducibility. The proposed electrode works well in a wide pH range 2.5-9.0 and demonstrates good discriminating power over a number of mono-, di-, and trivalent cations. The sensor has also been used as an indicator electrode in the potentiometric titration of silver(II) ions against NaCl solution. The sensor can also be used in non-aqueous medium with no significant change in the value of slope or working concentration range for the estimation of Ag⁺ in solution having up to 25% (v/v) nonaqueous fraction. Full article

► Show Figures

Figure 1

364 KiB

Open AccessArticle

Remote Query Resonant-Circuit Sensors for Monitoring of Bacteria Growth: Application to Food Quality Control

by Keat Ghee Ong, J. Samuel Bitler, Craig A. Grimes, Libby G. Puckett and Leonidas G. Bachas

Sensors 2002, 2(6), 219-232; https://doi.org/10.3390/s20600219 - 22 Jun 2002

Cited by 58 | Viewed by 11135

Abstract

This paper presents a technique for in-situ remote query monitoring of bacteria growth utilizing a printed thin or thick-film sensor comprised of an inductor-capacitor (LC) resonant circuit. The sensor, which is placed within the biological medium of interest and remotely detected using a loop antenna, measures the complex permittivity of the medium. Since bacteria growth increases the complex permittivity of a biological medium the LC sensor can be used to determine bacteria concentration. This paper presents results on monitoring of three different bacteria strains, Bacillus subtilis, Escherichia coli JM109, and Pseudomonas putida, demonstrating application of the sensor for monitoring bacteria growth in milk, meat, and beer. Due to its low unit cost and remote query detection, the sensor is potentially useful for commercial scale monitoring of food quality. Full article

► Show Figures

Figure 1

449 KiB

Open AccessArticle

Thin films of In₂O₃/SiO for Humidity Sensing Applications

by K. Arshak and K. Twomey

Sensors 2002, 2(6), 205-218; https://doi.org/10.3390/s20600205 - 21 Jun 2002

Cited by 47 | Viewed by 7091

Abstract

This paper documents the manufacture and testing of a humidity sensor based on a combination of In₂O₃/SiO. A number of different sensor samples have been produced by thermal deposition and the effect of varying the vacuum pressure has also been investigated. The AC and DC conduction mechanisms have been investigated. From the AC conduction studies, the tunneling conduction mechanism has been observed at low frequencies and the hopping conduction mechanism, for the majority of sensor samples, has been observed at high frequencies. The DC conduction mechanisms have indicated the possibility of spacecharge-limited conduction. The sensor with the highest humidity sensitivity of 1.145%/RH% is 85%In₂O₃/15%SiO, which is produced at a vacuum pressure of 2×10^-4mbar.From the point of view of temperature stability, the 55%In₂O₃/45%SiO samples produced at a vacuum pressure of 2×10^-4 mbar exhibit the lowest temperature sensitivity, 0.3%/oC. Full article

► Show Figures

Figure 1

111 KiB

Open AccessArticle

Chemical detection in liquid media with a refractometric sensor based on a multimode optical fibre

by K. Cherif, S. Hleli, A. Abdelghani, N. Jaffrezic-Renault and V. Matejec

Sensors 2002, 2(6), 195-204; https://doi.org/10.3390/s20600195 - 20 Jun 2002

Cited by 22 | Viewed by 9338

Abstract

In this paper the physical basis for the design of an optical fibre sensor suited for aqueous medium and gas phase based on the excitation of an evanescent wave at the core/cladding interface is developed. The detection based on the refractive index changes (between 1.41 and 1.45) of the infinite dielectric medium which can be an electrolyte or a sol-gel polymer deposited on the uncladed part of the fibre. Refractive indices of absorbent and volatile compounds such as fuel and unleaded gas were determined. Using a xerogel sensing layer as optical cladding, toluene detection in water was performed. The observed sensitivity is linear and the detection limit is 1% (in volume) toluene in water. Full article

► Show Figures

Figure 1

Journal Menu

Journal Browser

Sensors, Volume 2, Issue 6 (June 2002) – 4 articles , Pages 195-243

Further Information

Guidelines

MDPI Initiatives

Follow MDPI